Valves, Drains and Remodels
Shower and Tub Plumbing in Dundee, FL
Drips, sudden temperature changes, weak spray and slow drains traced to the valve, supply or drain, then fixed without tearing out more tile than necessary.
- 24/7 Emergency Service
- License CFC1431820
- Free Phone Estimates
- Veteran-Owned · Bonded & Insured
Behind the handle
Shower and tub plumbing in Dundee, FL usually comes down to the valve
The handle you turn is connected to a cartridge or valve that mixes hot and cold. When it wears, almost every shower complaint follows.
A worn cartridge causes drips from the head or spout, handles that are hard to turn and temperature that jumps when someone uses water elsewhere. Dundee's hard water speeds that wear, scaling the cartridge and clogging shower heads. Most shower and tub plumbing in Dundee, FL that we do starts with pulling the cartridge and seeing what minerals have done to it.
Not every problem is the valve. A slow drain is usually hair and soap in the trap, and water stains on a ceiling below a bathroom can come from a cracked drain, a failed pan or a leaking valve body. We work out which before suggesting any demolition.
For remodels, we rough in valves and drains to code so tile and glass go over plumbing you can trust. Our main shower and bathtub plumbing page covers the full range.
Repair choices
Cartridge replacement or full valve replacement?
New cartridge
- Drips and stiff handles from a worn or scaled cartridge
- Valve body is sound and parts are available
- Done from the front, without opening the wall
- Often restores smooth temperature control
New valve
- Valve body is cracked or leaking inside the wall
- Parts for an old valve are no longer made
- You want pressure-balancing or thermostatic control
- Planned alongside a bathroom remodel
Bath services
Shower and bathtub work we handle
Valve repair
Cartridges and valves rebuilt or replaced to stop drips and temperature swings.
Tub and shower installs
New tubs, shower bases and shower systems plumbed to code.
Drain clearing
Slow tub and shower drains cleared and trap problems corrected.
Walk-in conversions
Tub-to-shower conversions with drains and valves placed correctly for the new layout.
Hidden leak checks
Valve, pan and drain leaks located before tile comes off. See our Dundee leak detection service.
Signs to act on
When your shower or tub needs a plumber
- Temperature jumps when a toilet flushes or a tap opens
- The head or spout keeps dripping after it is turned off
- Water stains on the ceiling below the bathroom
- Loose or cracked tiles around the tub or shower
- A drain that stays slow even after you clean it
- Weak spray at the shower but normal pressure elsewhere
From the blog
Helpful plumbing guides
Revamping Home Comfort: How to Plan a Shower and Bathtub Installation
A new shower or tub is a plumbing project first and a design project second. Here is how to plan a shower and bathtub installation that works for years.
Read articleShower and Tub Plumbing Problems in Bradenton, FL: A Troubleshooting Guide
Drips, weak spray, sudden cold bursts and slow drains: a symptom-by-symptom guide to shower and tub plumbing problems in Bradenton homes and what fixes them.
Read article
Dundee questions
Shower and Tub Plumbing in Dundee: common questions
Why does my shower go cold or hot when someone flushes a toilet?
Flushing draws cold water away from the shower, and an older valve without pressure balancing cannot compensate. A worn or scaled cartridge in a pressure-balancing valve can cause the same thing. Replacing the cartridge often fixes it; if the valve type cannot balance pressure, we can quote a modern replacement.
Can a shower valve be fixed without removing tile?
Usually, yes. Cartridges and most valve parts are reached from the front once the trim is removed. Opening the wall is only needed when the valve body itself is leaking or must be replaced, and even then access can sometimes be made from the other side of the wall.
What plumbing does a tub-to-shower conversion need?
The drain often has to move or be resized for a shower base, the valve may be raised to a comfortable height and the shower head arm relocated. We plan those changes before the old tub comes out so the new layout drains properly and the valve sits where you want it.
How can I keep shower heads from clogging in hard water?
Soak the head in vinegar every few months to dissolve mineral deposits, or choose a model with flexible rubber nozzles you can rub clean. If flow stays weak after cleaning, the restriction is likely in the cartridge or valve, which we can check.
Have another question? Browse our plumbing FAQ or call (941) 541-7473.
Shower dripping or running hot and cold in Dundee?
Tell us what the shower or tub is doing. We will explain the likely cause and give you a free phone estimate.
Request Your Plumbing Service
Share a few details and we’ll reach out to schedule your appointment. For emergencies, please call.
Redemption Plumbing Services · 2908 Florida Blvd, Bradenton, FL 34207 · Mon–Fri 8AM–5PM · Sat 8AM–12PM · 24/7 emergency