Valves, Drains & Conversions
Shower and Tub Plumbing in Palmetto, FL
Drips that will not stop, water that runs hot then cold, drains that pool around your feet. We fix shower and tub plumbing at the valve, the supply and the drain, without tearing out more tile than needed.
- 24/7 Emergency Service
- License CFC1431820
- Free Phone Estimates
- Veteran-Owned · Bonded & Insured
Behind the tile
Shower and tub plumbing in Palmetto, FL, from the valve back
Every shower hides a mixing valve, two supply lines, a drain and an overflow. Each fails in its own way.
Most shower and tub plumbing in Palmetto, FL comes back to two local facts. The first is hard water. Minerals scale the valve cartridge until it no longer seals or mixes properly, which shows up as a drip from the head, a handle that is hard to turn or a temperature that drifts mid-shower.
The second is age. Bathrooms in many of the older bungalows and block homes still have galvanized supply pipe behind the wall and original tub drains below. Galvanized pipe narrows as it rusts inside, so pressure at the shower drops while the rest of the house seems fine. A new valve on old pipe only fixes half the problem.
So when we open a wall to replace a valve, we look at the pipe feeding it. If it is galvanized, replacing those few feet while the wall is open is usually the sensible choice. For a whole-house view, see our page on repiping older Palmetto homes, or read more about bathroom shower and tub services.
Symptoms
Shower and bath problems we are called about
- A showerhead or tub spout that keeps dripping after it is turned off
- Temperature that jumps when a toilet flushes or a faucet opens
- Weak pressure at the shower only
- A tub drain that pools water or gurgles
- Stains on the ceiling below an upstairs bathroom
- Loose tiles or soft grout around the tub or shower floor
What we do
Shower and bathtub services in Palmetto
Valve and cartridge repair
Scaled or worn cartridges replaced, and older valves upgraded to pressure-balancing valves that hold temperature steady.
Tub-to-shower conversions
Drains relocated and valves set at the right height for a walk-in shower, roughed in before tile goes up.
Drain and overflow repair
Slow drains cleared, and leaking drain shoes or overflow gaskets replaced.
Remodel rough-in
New valves, supply lines and drains placed to code so the tile and glass go in over sound plumbing.
The visit
How we approach a shower or tub repair
Listen to the symptom
A drip, a temperature swing and a slow drain each point to a different part, so we ask before we arrive.
Check access first
Many valves can be reached through the trim or an access panel. We open tile only when there is no other way.
Price the options
A cartridge swap and a full valve replacement are priced separately, and you choose before we begin.
Test and clean
We run hot and cold, check for leaks at the valve and drain, and leave the bathroom tidy.
From the blog
Helpful plumbing guides
Revamping Home Comfort: How to Plan a Shower and Bathtub Installation
A new shower or tub is a plumbing project first and a design project second. Here is how to plan a shower and bathtub installation that works for years.
Read articleShower and Tub Plumbing Problems in Bradenton, FL: A Troubleshooting Guide
Drips, weak spray, sudden cold bursts and slow drains: a symptom-by-symptom guide to shower and tub plumbing problems in Bradenton homes and what fixes them.
Read article
Palmetto questions
Shower and Tub Plumbing in Palmetto: common questions
Why does my shower go cold when someone flushes?
The toilet draws cold water away from the shower, and an older valve cannot compensate, so the mix swings hot or cold. A pressure-balancing or thermostatic valve adjusts automatically and keeps the temperature steady. In many cases the existing valve body can take a newer cartridge, which avoids opening the wall.
Should I replace old pipe behind the shower during a remodel?
If it is galvanized, yes. The wall is already open, so the extra cost is small compared with opening new tile later. Galvanized pipe narrows and rusts from the inside, and it is often the reason for weak shower pressure. Copper or PEX in good condition can usually stay. We check before you commit to tile.
What is involved in a tub-to-shower conversion?
The old tub comes out, the drain is moved to suit the new shower base, and the valve and head are reset at shower height. Those plumbing changes have to be finished and tested before the waterproofing and tile. We coordinate with your remodeler so the rough-in is ready on schedule.
Why is my tub draining slowly?
Hair and soap scum caught on the stopper linkage are the usual cause, and hard water makes that buildup stickier. If clearing the stopper does not help, the trap or the line beyond it may be restricted. Our Palmetto drain clearing service handles blockages further down the line.
Have another question? Browse our plumbing FAQ or call (941) 541-7473.
Shower or tub giving you trouble in Palmetto?
Describe the drip, the temperature swing or the slow drain, and we will give you a free phone estimate and an upfront price before any work begins.
Request Your Plumbing Service
Share a few details and we’ll reach out to schedule your appointment. For emergencies, please call.
Redemption Plumbing Services · 2908 Florida Blvd, Bradenton, FL 34207 · Mon–Fri 8AM–5PM · Sat 8AM–12PM · 24/7 emergency