Drips, Leaks & New Fixtures
Faucet Repair & Installation in Tampa, FL
We identify the brand and valve before we order a part, and we look at the stops and supply lines under the sink, which is where many Tampa faucet problems really start.
- 24/7 Emergency Service
- License CFC1431820
- Free Phone Estimates
- Veteran-Owned · Bonded & Insured
Under the sink
Faucet repair in Tampa often starts below the faucet
A dripping spout gets noticed. A corroded valve under the cabinet usually does not, until it will not close.
Most faucet repair in Tampa, FL comes down to a worn cartridge, a hardened O-ring or a seat that no longer seals. Those are quick fixes once the valve is identified, which is why we confirm the manufacturer and cartridge type before we swap anything. A close-enough part tends to drip again within weeks.
Older houses across Hyde Park, Seminole Heights and the mid-century neighborhoods add a second layer. Their sinks are often fed through original multi-turn stops and galvanized nipples, and a brand-new faucet connected to a half-clogged supply will still run weak. When we see that, we replace the stops and lines in the same visit so the new fixture performs the way it should.
Tampa's water is treated surface water from the Hillsborough River with chloramine added for disinfection. Over years, rubber washers and seals in any fixture wear and harden, so a faucet that started dripping slowly is usually telling you a seal has reached the end of its life.
Symptoms
Faucet problems worth a call
- A steady drip from the spout after the handle is closed
- Water seeping around the base or under the handle
- A handle that is stiff, wobbly or will not stop at off
- Spray that sputters or splits from a scaled aerator
- Hot and cold that will not mix smoothly
- Damp particleboard or stains on the sink cabinet floor
- A shut-off valve that will not turn or drips when touched
Repair or replace
When to rebuild a faucet and when to replace it
We give you both options with a price for each, and you decide.
Repair usually makes sense when
- The faucet body is solid and the finish is in good shape
- Replacement cartridges are still available for that model
- Only one part, such as a seal or aerator, has failed
- You like the fixture and it suits the room
Replacement usually makes sense when
- The body is cracked or corroded around the base
- Parts are discontinued or hard to source
- Several components are worn at the same time
- You are updating the sink, counter or style anyway
What we fix
Faucets and valves we work on across Tampa
Kitchen faucets
Single-handle, pull-down and side-spray kitchen faucets repaired or replaced, with new supply lines.
Bathroom lavatory faucets
Drips and loose bases fixed on widespread, centerset and single-hole faucets. Related sink plumbing in Tampa covers the drain side.
Tub and shower valves
Dripping tub spouts and shower handles traced to the cartridge or valve body behind the wall.
Shut-off stops
Seized or weeping stops swapped for quarter-turn valves you can close quickly in an emergency.
Outdoor hose bibs
Leaking spigots on the side of the house repaired or replaced before the drip runs up your bill.
From the blog
Helpful plumbing guides
Cost of Faucet Installation in Bradenton: What Changes the Price
Two faucet installs can look identical and price very differently. The real factors behind the cost of faucet installation in Bradenton, and how to get a precise quote.
Read articleWhy Faucets Wear Out Faster in Bradenton, FL: A Hard Water Guide
White crust, a stiff handle and a drip that won't quit are classic hard water damage. Here's what's happening inside your Bradenton faucets and how to slow it down.
Read articleFaucet Repair vs. Replacement in Bradenton, FL: How to Decide
A dripping or stiff faucet can often be fixed, but not always. Here is how Bradenton's hard water affects faucets and how to decide between repair and replacement.
Read article
Tampa questions
Faucet Repair & Installation in Tampa: common questions
Why does my new faucet have weak pressure in an older Tampa house?
The faucet is rarely the cause. In older homes the supply often runs through galvanized pipe or worn multi-turn stops that have narrowed inside. When the old faucet came off, debris may also have lodged in the new aerator. We check the stops, lines and aerator, and if the pipe itself is the restriction we explain the options for pipe repair and replacement.
Is it worth rebuilding a faucet instead of replacing it?
Often, yes. If the body and finish are in good shape and the cartridge is still made, a rebuild is usually the less expensive choice and the faucet will work like new. If parts are discontinued or the base is corroded, replacement is better value. We price both so you can compare before we start.
Should I replace the shut-off valves when I replace a faucet?
If they are the old multi-turn style or show any green or white crust, we recommend it. Stops that have not been turned in years can fail the moment they are used. Replacing them while the cabinet is already open adds little time and gives you a shut-off you can trust.
Have another question? Browse our plumbing FAQ or call (941) 541-7473.
Dripping faucet in your Tampa home?
Send us a photo of the faucet or describe it on the phone and we will give you a free estimate. Call (941) 541-7473.
Request Your Plumbing Service
Share a few details and we’ll reach out to schedule your appointment. For emergencies, please call.
Redemption Plumbing Services · 2908 Florida Blvd, Bradenton, FL 34207 · Mon–Fri 8AM–5PM · Sat 8AM–12PM · 24/7 emergency